Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • vw ®

GIAC performance software for the vw ® Jetta / GLI ® ® MK6 2009 - Present

2.0 Turbo TSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. This calibration is compatible with vehicles that have no other upgrades to basic "bolt-ons".
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
240 HP  260 Ft-Lbs
GIAC Race Mode**
255 HP  275 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* Premium Fuel is required.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
Dyno Plots
vw Jetta / GLI ® MK6 2009 - Present - GIAC Stage_1_Plus dynoplot
Supported ECUs
1K0907115AB
1K0907115AD
1K0907115AE
1K0907115AF
1K0907115AL
1K0907115AM
1K0907115AP
1K0907115AQ
06j997029D
06j997029E
06j906027J
06j906027K
06j906027FH
06j906027FJ
Info
GIAC Stage 3 K04 adds horsepower, torque and more throttle response throughout the power band. A K04, stock injectors, and FMIC are required to run this calibration.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
300 HP  330 Ft-Lbs
GIAC Race Mode**
365 HP  365 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* Premium fuel is required.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
Dyno Plots
vw Jetta / GLI ® MK6 2009 - Present - GIAC Stage_3_K04 dynoplot
Supported ECUs
1K0907115AF


Transmission Controllers


Info
GIAC's two stages of DSG software truly optimize launch control, shift and torque limiter features for the end users performance modifications. Matching this program with the GIAC engine calibration will give the best results.
* Faster, smoother trans
Supported ECUs



Other products



thumb
Hand Held Flashloader Switcher

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the OBD port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.

More info.