Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • vw ®

GIAC performance software for the vw ® Golf ® / GTI ® ® MK6 2009 - 2013

2.0 Turbo TSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. This calibration is compatible with vehicles that have no other upgrades to basic "bolt-ons".
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
240 HP  260 Ft-Lbs
GIAC Race Mode**
255 HP  275 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* Premium Fuel is required.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
Dyno Plots
vw Golf ® / GTI ® MK6 2009 - 2013 - GIAC Stage_1_Plus dynoplot
Supported ECUs
06J906027H
06J906027J
06J906027K
06J906027DN
1K0907115AL
1K0907115AM
1K0907115AP
1K0907115AQ
1K0907115AS
1K0907115AT
1K8907115
5K0907115
Info
GIAC Stage 3 K04 adds horsepower, torque and more throttle response throughout the power band. A K04, stock injectors, and FMIC are required to run this calibration.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
300 HP  315 Ft-Lbs
GIAC Race Mode**
365 HP  365 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* Premium fuel is required.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
Dyno Plots
vw Golf ® / GTI ® MK6 2009 - 2013 - GIAC Stage_3_K04 dynoplot
Supported ECUs
1K0907115AF


Transmission Controllers


Info
GIAC's two stages of DSG software truly optimize launch control, shift and torque limiter features for the end users performance modifications:

Stage 2: (MSRP: $650.00 USD/$550.00 USD with GIAC Engine Flash)
* Faster, smoother transitions between gears
* Launch control limiter set at 3700 RPM
* Hard rev limiters slightly bumped over stock to be compatible with most aftermarket tunes
* Remapped sport mode "drive program" with improved ability to hold gears and overheating protection
* No automatic kick down in manual mode
* Increased torque limits set to over 500 nm
Supported ECUs
02e300051R_1975
02e300053n_2207


Other products



thumb
Hand Held Flashloader Switcher

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the OBD port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.

More info.