Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • vw ®

GIAC performance software for the vw Scirocco R ® MK3 2009 - 2012

2.0 Turbo FSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. A high pressure fuel pump is required to run this calibration.
Good intake, exhaust, and inter-cooler upgrades will help to achieve optimum performance gains.
OEM Horsepower
and Torque
261 HP  258 Ft-Lbs
GIAC Pump Mode*
325 HP  330 Ft-Lbs
GIAC Race Mode**
340 HP  350 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
1K8907115B
Info
GIAC Xtreme adds horsepower, torque and more throttle response throughout the power band. A GIAC approved 3 inch intake, turbo back exhaust, high pressure fuel pump, fuel pressure regulating valve, intercooler and 98 RON or higher is required to run this calibration.
OEM Horsepower
and Torque
261 HP  258 Ft-Lbs
GIAC Pump Mode*
375 HP  355 Ft-Lbs
GIAC Race Mode**
397 HP  365 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
thumb
Supported ECUs
1K8907115B



Other products



thumb
Fuel Pump - 2.0T and 3.0TFSI

This kit allows for more low pressure fuel delivery, in a variety of high fuel demand situations. It increases the flow rate of the low pressure fuel system before the regulator by over 250 liters per hour. Some GIAC supported applications perform best with a low pressure fuel pump upgrade, while other applications we support can use it to run a little more E85 with improved performance and driveability. Previously, one of our "K04 Extreme" customers added the fuel pump kit, without any other hardware of software changes and improved his 1/4 time by 3/10ths of a second at almost 4mph faster.

More info.
thumb
Hand Held Flashloader Switcher

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the OBD port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.

More info.