Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • audi ®

GIAC performance software for the audi TTS MK2 2008 - Present

2.0 Turbo FSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. A is required to run this calibration.
Quality intake and exhaust upgrades will improve performance.
OEM Horsepower
and Torque
267 HP  258 Ft-Lbs
GIAC Pump Mode*
340 HP  330 Ft-Lbs
GIAC Race Mode**
370 HP  370 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8J0907115Q
8J0907115AS


Transmission Controllers


Info
GIAC's two stages of DSG software truly optimize launch control, shift and torque limiter features for the end users performance modifications. Matching this program with the GIAC engine calibration will give the best results.
* Faster, smoother transitions between gears
* Launch control limiter set at 3700 RPM
* Hard rev limiters slightly bumped over stock to be compatible with most aftermarket tunes
* Remapped sport mode "drive program" with improved ability to hold gears and overheating protection
* No automatic kick down in manual mode
* Increased torque limits set to over 500 nM
Supported ECUs
02E300012G_1903
02E300012G_1972
02e300013_2204
02E3000057R_3116
02E300057T_3110
02E300058S_3512


Other products



thumb
Hand Held Flashloader

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the DME port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.