Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • audi ®

GIAC performance software for the audi TT MK2 2006 - Present

2.0 Turbo TSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. This calibration is compatible with vehicles that have no other upgrades to basic "bolt-ons".
Quality intake and exhaust upgrades will improve performance.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
244 HP  275 Ft-Lbs
GIAC Race Mode**
260 HP  290 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 91 (r+m)/2 or 95 RON fuel compatible. 93 (r+m)/2 or 98 RON equivalent fuel for optimum results.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8J0907115L
8J0907115M
8J0907115AE
Info
GIAC Stage 2 adds horsepower, torque and more throttle response throughout the power band. A intake (with a good MAF signal) and exhaust is required to run this calibration.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
270 HP  300 Ft-Lbs
GIAC Race Mode**
295 HP  310 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 91 (r+m)/2 or 95 RON fuel compatible. 93 (r+m)/2 or 98 RON equivalent fuel for optimum results.
** 104 RON fuel compatible. 109 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8J0907115L


Transmission Controllers


Info
GIAC's two stages of DSG software truly optimize launch control, shift and torque limiter features for the end users performance modifications. Matching this program with the GIAC engine calibration will give the best results.
* Faster, smoother transitions between gears
* Launch control limiter set at 3700 RPM
* Hard rev limiters slightly bumped over stock to be compatible with most aftermarket tunes
* Remapped sport mode "drive program" with improved ability to hold gears and overheating protection
* No automatic kick down in manual mode
* Increased torque limits set to over 500 nM
Supported ECUs
02e300051R_1975
02e300053n_2207


Other products



thumb
Flashloader Mobile Device

The GIAC Flashloader Mobile (FLM) Device is a new tool that allows enthusiasts to load or remove GIAC performance programs on to their vehicle. The FLM is pocket-sized, durable and does not require a laptop or PC during the flash. Files and commands are stored on a USB memory stick, that can be customized by the end user, to convert the device from flashing tool, to logger, to performance mode switcher, to code clearer or to some combination of each.

More info.
thumb
Hand Held Flashloader Switcher

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the OBD port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.

More info.